Pedal assist sensitivity and sensor ratio parameter settings

 

This is how to perform the settings change on your Computer Display

 

Definitions:

Short Press: Press and Release

Long Press: Press and Hold

 

STEP 1: Turn on your E-Bike

-Long Press "M" Key until the Bike Powers on

 

STEP 2: Enter the Settings Menu

-Long Press both "+ and -" Keys until the screen switches

-Do this 2 times until you reach the screen that says "P3"

 

 

STEP 3: Enter Display Password - "2962"

-Use "+ and -" Keys to select numbers

-Short Press "M" key to switch to the next number

-Enter "2962" and short press "M" Key to get to the User Settings Menus

 

 

Once the password is entered correctly, VOL 1 will appear, press "+ and -" keys to toggle through the 7 menu options:

 

VOL 1 = Voltage levels

ScA 2  = PAS parameter settings (Pedal Assist System)

cur 3  = Current / Power supply settings for controller

PAS 4 = PAS sensor settings  (Pedal Assist System)

SPS 5 = Speed sensor setting

Hnd 6 = Throttle function settings

SYS 7 = System settings

 

 

STEP 4: Entering PAS 4 menu options

- Short Press "+ and -" keys to toggle through Menu Options

-Once you see "PAS 4", short press "M" Key to enter this setting category

 

 

 

Step 5: Navigating within PAS 4 menu options

- Bypass the cun- (f or b) page (shown below), short press "M" Key to get to next page - Pedal Assist Settings (PAS) sensor sensitivity setting

 

 

PAS sensor sensitivity setting: (shown below)

- Check the settings and confirm that Scn (shown below, right) is set to 2, 2 is the highest sensitivity (2-9 are the options)

 

 

-short press "M" Key to get to next page - Pedal Assist Settings (PAS) Sensor ratio Parameter setting (shown below)

-Check that the PAS Sensor ratio Parameter setting is set to "n-064"

 

 

Long Press "M" key twice to exit the menu, and go back into the standard screen.