519
If you feel that your bike is generating too much Assist Power, you can change the distribution of power from 0-5 levels to 0-9 levels. With more levels, the ramp-up or power will feel more gradual.
This is how to perform the settings change on your Computer Display
Definitions:
Short Press: Press and Release
Long Press: Press and Hold
STEP 1: Turn on your E-Bike
-Long Press "M" Key until the Bike Powers on
STEP 2: Enter the Settings Menu
-Long Press both "+ and -" Keys until the screen switches
-Do this 2 times until you reach the screen that says "P3"
STEP 3: Enter Display Password - "2962"
-Use "+ and -" Keys to select numbers
-Short Press "M" key to switch to the next number
-Enter "2962" and short press "M" Key to get to the User Settings Menus
Once the password is entered correctly, VOL 1 will appear, press "+ and -" keys to toggle through the 7 menu options:
VOL 1 = Voltage levels
ScA 2 = PAS parameter settings (Pedal Assist System)
cur 3 = Current / Power supply settings for controller
PAS 4 = PAS sensor settings (Pedal Assist System)
SPS 5 = Speed sensor setting
Hnd 6 = Throttle function settings
SYS 7 = System settings
STEP 4: Entering SCA 2 menu rom menu options
- Short Press "+ and -" keys to toggle through Menu Options
-Once you see "SCA 2", short press "M" Key
STEP 5: Select Your Power Level Selection
-You can now select your power level selection (0-3/1-3/0-5/1-5/0-7/1-7/0-9-1-9). Toggle through options by Short Pressing "+ and -" keys
-Keep in mind that if you select any level that starts with level 1, you cannot disengage pedal assist while riding unless you repeat this process and select a level that starts with 0
-Once you decide what level you want, Long Press "M" key twice, Until back into the standard Screen.
Here is the PAS percentage breakdown per level
Please note, you can further customize the percentage output per level. If you wish to do so, please refer to the User manual below
