As of October 28th, Gen 3 Mobility, LLC has ceased operations and is no longer offering customer support.
During our brief existence we were fortunate to service many incredible customers, build some amazing products and have fun doing it.
We thank you for your support.
Installing brake lever
Replacing brake levers: Align the gaps in the adjuster and lock ring ![][1] Pull back on the housing and guide the cable through the opening ![][2] Remove the cable head from the cradle on the lever blade ![][3] Disconnect the motor cut off cable ![][4] Loosen the 32mm hex/allen pinch bolt and remove grip 
Controller access and wiring diagram (Stride)
To do this you will just need a Phillip's #2 screwdriver ----------------------------------- **Wiring layouts on each plug: (picture below)** **Battery supply** (red plug connected to red plug) red to red Black to black **Cadence sensor connection** (black plug connected to black plug, with finger release): Or…
Bike measurements and geometry - (Groove, Outcross, Flex, and Stride)
_**Saddle Heights Measured from the Floor to the top of the Saddle**_ **STRIDE** Min: 32.35" // 83.2cm Max: 41" // 104cm Lowest seat position from the ground: 30" Lowest seat position from bottom bracket: 22" Lowest seat position from the furthest point of the pedal stroke: 28" Center of seat/seatpost to handl…
Ebike error codes (Groove, Outcross, Stride, Flex)
Electric bikes: ERROR CODE DEFINITION 21 Current Abnormal 22 Throttle Abnormal 23 Motor Phase 24 Signal of Motor Hall Abnormal 25 Brake Abnormal 26 Communication Abnormal 30 Display or controller communication issue
Replace Display / Throttle on Ebikes
# This is how to replace your Display/Throttle Unit on our E-Bikes. _Step 1. Remove the Coil wire cover from the wire cluster_ ![][1] _Step 2. Isolate and unplug the Display unit from the wire cluster._ ![][2] _Step 3. Remove the Grip _ - Loosen the 3mm Allen key and slide the grip outwards off the handlebar ![…
Changing the Seat / Saddle of your ebike
**Tools needed**: 6mm allen (hex) key **Seatpost parts diagram:** ![][1] **Steps for removal of saddle:** * Loosen (counter-clockwise) the seatpost clamp bolt, this doesn't need to be fully unthreaded. (If bolt comes undone, is not easy to reassemble with a seat in the way, remove seat/saddle and reassemble. …
